Description
SM205 Light Switch Adapter
Material:
3D printed (custom colours are available)
Compatibility:
Philips Hue Wireless Dimmer Switch
1 gang UK light switches
Fitting instructions:
1. Unscrew the two retaining screws on the light switch
2. Attach the adapter on top of the light switch and screw both back into the wall using the the longer screws supplied
3. Remove the insert from both Philips Hue flush plates and snap fit the mounts onto the adapter
Kit contains:
Adapter
Two mounting screws
Jeff (verified owner) –
3D printing finish is not as glossy as the other mounts, but it looks fine and does a great job.
Uploaded image(s):
Ian (verified owner) –
Does the job, but the fit for the Philips remote is too tight so impossible to get it out without pushing it from the back (impossible to do with the unit fixed to the switch/wall). Also not the best finish, i.e. clearly 3D printed, so not very smooth.
Iain (verified owner) –
Lovely products would have been 5 stars except we have 2 of the other modles we brought through amazon which are in a smooth finish which these do not match
Matthew B. (verified owner) –
The buttons on a few of my switches are larger than the opening on this model. It would be good if one could be produced where by the opening is taller. I will probably try and cut a larger opening on the one I have. Ultimately, this isn’t a fault of the product though and more to do with my light switches! If though you have switches that are right next to a door frame etc then these are the perfect solution.
Michael Jones (verified owner) –
My switches have a slight curve (not flat like in the illustration), so there are slight gaps at the bottom and top between the adapter and switch unit. This is not, however, a fault with the adapter.